Culligan Iron-Cleer Plus Specifications download pdf (Page 44)

Familiarize yourself with the replacement procedures and component parts thoroughly before attempting any repair.

Circuit Board

To replace the AccuSoft Plus circuit board, refer to the

parts list and proceed as follows

1. Remove the timer cover by unsnapping it from the

back plate.

2. Unhook the circuit board mounting plate by lifting the

top snap and removing from the backplate.

3. Remove all connected wire leads from the board.

4. Unsnap the circuit board from the mounting plate.

See Figure 15.

5. The new circuit board can be installed by reversing

the steps 1-4 above. When reassembling the

mounting plate to the backplate, it is easiest to hook

the top snap first and then gently push the base in

until it snaps into place.

Service

40 Culligan

Iron-Cleer

Plus Water Filters

Caution! The wire connectors must be connected to the circuit board properly. The wires must exit the plug-in

connector opposite of the raised white base of the circuit board connector.

Caution! Extra care should be taken when connecting the 2.5 vac and 24 vac power. Failure to connect properly

will result in damage to the circuit board.

Warning! Disconnect all electrical power to the unit before servicing. Bypass the unit and relieve system

pressure before attempting repair.

Caution! Do not touch any surfaces of the

circuit board. Electrical static discharges

may cause damage to the board. Handle

the AccuSoft circuit board by holding only

the edges of the circuit board. Keep

replacement boards in their special anti-

static bags until ready for use. Mishandling

of the circuit board will void the warranty.

Caution! Grip all connections to the circuit

board by the connecting terminals for

assembly and disassembly. Failure to do

so could result in damage to the wire leads

or connecting terminals.

Figure 15

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51 52

No comments

Culligan Iron-Cleer Plus Specifications Page 44