Culligan Iron-Cleer Plus Specifications download pdf (Page 42)

Complaint Problem Cause

Solution

Water is running to

drain continuously.

A. Control valve is

stuck in regeneration

cycle.

1. Electrical service to control(s) has

been interrupted.

1. Assure continuous electrical service is

available. (check plug, breaker, fuse, etc.)

2. Faulty circuit board.

2. Replace circuit board..

3. Faulty drive motor.

3. Replace drive motor.

4. Foreign material lodged in piston.

4. Disassemble and clean control valve,

replace seals, spacers and piston

assemblies.

Blue green staining. A. Corrosive water

condition in copper

distribution piping

system.

1. Low pH condition of the raw water

supply.

1. A Cullneu® filter may be required to

elevate the pH - consult factory.

2. In rare occasions, highly aerated

water in combination with a specific

water supply can create a slightly

corrosive condition.

2. Install a polyphosphate cartridge filter

after the Iron-Cleer Filter System to protect

the distribution piping.

Compressor doesn’t

run.

1. Compressor unplugged.

1. Plug it in.

2. Relay settings incorrect.

2. Set relay correctly.

3. Bad relay.

3. Replace relay.

Compressor run with

excessive noise.

1. Dead head pressure is 65 psi.

1. Consult factory.

2. Dead head pressure is 65 psi.

2. Rebuild compressor.

Compressor runs

continuously.

1. Incorrect relay settings

1. Set relay settings correctly.

2. Bad relay.

2. Replace relay.

38 Culligan

®

Iron-Cleer

®

Plus Water Filters

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 51 52

Comments to this Manuals

No comments