Culligan Iron-Cleer Plus Specifications download pdf (Page 15)

Aeration Tank Installation

Aeration Head Assembly Quick Install

1. Insert the white disperser into the bottom of the aeration head.

Twist it clockwise to lock it into position.

Note: The small hole in the white disperser must be in the position

shown after it is locked into position.

2. Insert the small grey rigid tube into the white disperser and up into

the aeration head. Note: The tube must go into the disperser

approximately 8-1/4”, until it contacts the stop molded into the aeration

head. Approximately 8-1/4” will remain sticking out of the white

disperser. If more than this amount is sticking out of the disperser,

the tube is not fully inserted into the aeration head. The tube can be

marked with a pencil at 8-1/4” as a visual guide. See figure 9.

3. Locate the large tube provided and mark it 4-3/8” from the end. Insert

it into the white disperser and aeration head until it contacts the stop

molded into the aeration head. Approximately 4-3/8” of the tube will be

in the white disperser when properly seated. Use the mark to verify it

is inserted deep enough. See figure 9.

4. Tighten the screw on the white disperser to secure the two tubes as

shown.

5. Install the assembly onto a tank.

6. Locate the bypass valve, inlet elbow, and 1” threaded adapters.

7. Lightly lubricate the external o-rings on the bypass valve with silicone

lubricant. Connect the bypass valve to the inlet and outlet connections

on the rear of the aeration head assembly.

Note: Tighten the plastic nuts by hand only.

Installation 11

Figure 8

Hole in disperser must be in this position when locked

Figure 9

Long Large Tube

Short Small Tube

Disperser

Figure 10

Figure 11

Bypass Valve

Retaining Screw

Lubricate O-ring

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

No comments

Culligan Iron-Cleer Plus Specifications Page 15