Culligan GoodWater Machine DrinkingWater System Specifications download pdf (Page 9)

IN-PLANT PREPARATION / 7

In-Plant Preparation

To help assure quick and trouble-free installation of the

Aqua-Cleer

system, the following preparation steps should

be performed in the dealer facility. Refer to Fig. 2. Cleanliness

is essential in the In-Plant Preparation procedure. Be sure to

wash your hands throughly before handling filters.

The use of surgical gloves is strongly recommended.

Filter Assembly Preparation

• Activated Carbon Filter

The activated carbon filter must be thoroughly flushed

to remove carbon dust which can plug the manifold or

RO membrane filter. To perform this procedure, it is

necessary to use a clean, spare Aqua-Cleer H-83 (or

H-82, 52, 53) series or “System” series filter housing

(Fig. 4) as a service housing.

1. Install the activated carbon cartridge into the service

housing.

FIG. 4

2. Connect the outlet of the service housing to a source

of clean, filtered water.

3. Connect the inlet of the service housing to a suitable

drain.

4. Slowly turn on the water and back-flush the filter for

5 minutes at a rate of 1-2 gpm (4-7 L/min). Turn the

water on and off several times during flushing to help

loosen carbon particles from the filter.

5. Reverse the connections and forward flush the filter

briefly until the water runs clear.

6. Remove the activated carbon filter cartridge from the

service housing and set it aside in a clean location for

installation into the Aqua-Cleer system.

• Sanitize Filter Assembly

The Aqua-Cleer system may be sanitized with either

5-1/4% liquid chlorine bleach or a fresh bottle of

consumer grade hydrogen peroxide.

NOTICE: Chlorine will damage the RO membrane

filter in this system. Remove the RO membrane filter when

using chlorine bleach to sanitize.

NOTICE: Do not use hydrogen peroxide if iron is present

in the raw water supply. This combination will damage

the RO membrane filter.

1. Pull the u-clip from the rear of the particle filter

housing ①

2. Insert the u-clip into the two square holes at the

bottom rear of the manifold. Push up to release the

filter housing.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Comments to this Manuals

No comments

Culligan GoodWater Machine DrinkingWater System Specifications Page 9

Comments to this Manuals

Related products and manuals for Water dispensers Culligan GoodWater Machine DrinkingWater System