Culligan Platinum Series Specifications download pdf (Page 38)

36 Culligan Gold Series

™

Water Softener

Manual Cycling

Statistical Function Timeout

If no key activity occurs for a period of 600 seconds (10 minutes) while in statistic functions mode, the mode will time out and

return to the time of day display. An exception is that the flow rate and % capacity remaining will not time out but will remain

displayed until a key is pressed. Pressing the "Statistics" key after the last standard statistics display will return the unit back

to the time display.

Manual Control Cycling

The control can be manually cycled through a regeneration to troubleshoot the control or verify that the set-up is complete.

When a control is manually cycled back to the service position, the statistical counters of capacity remaining, days since last

regeneration, last slow rinse time and the number of regenerations in the last 14 days and the life of the unit are not to be

reset or updated. If the control is allowed to time out from the last position back to service (Home), the applicable statistical

counters are to be reset or updated. A manual cycling of the control can be accomplished by following the steps as outlined

below.

1. While in the service mode, press the "Statistics" key.

2. Press the "+" key to display the current motor position.

3. Press and hold the "Regen" key for 3 seconds until the regeneration is started. Once regeneration is active, the

"Regen" key will be ignored until the control returns to the service or "home" position.

4. The REGEN icon will flash and the motor will move the control to Backwash position.

5. Press the "+" key to cycle to the next position and remain there until the cycle times out or the control is manually

indexed.

6. Continue to press the "+" key until the control returns to the service (Home) position. In order to step through the cycles

again, repeat at step 3.

Home/Service

• To start manual cycling, press the STATISTICS key, then the “+” key

• In the Home position, the display will alternate between HM and 00

• Depending on operating mode - clock, meter or sensor - the left of the display will be blank, or an F (if flow meter

attached) or an A (if Aqua-Sensor

attached) will appear.

• The center digit is the regeneration trigger indicator (seeding notices section)

Note: If the "-" key is pressed at any time, the control will move back to the first item in the statistics menu. Pressing

the "+" key from the statistics menu would move the display back to the current diagnostic cycle. The "+" key will be

ignored once the control returns back to the home position.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 70 71

No comments

Culligan Platinum Series Specifications Page 38