Culligan Platinum Series Specifications Page 30
- Page / 71
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
28 Culligan Gold Series
™
Water Softener
Programming
• Pre-Rinse Mode - This setting will only be active if dip#9 is on. The display will show "PRE-" for two seconds and then
"RINSE" in the left most characters of the display. When "RINSE" is shown the right most character of the display will
flash "N" and toggle to "Y" with the use of the "+" or "-" keys.
Pressing the "Status" key will save the setting and move to the next programming step.
• Pre-Rinse Time Duration - This setting is used to set the length of time that
the control will be in the fast rinse position before returning to the Service
(Home) position. The display will show "RINS" and XX where XX is the length
in minutes that the control is to pre-rinse as well as the "FAST RINSE" icon.
Adjust the XX value with the "+" and "-" keys.
Pressing the "Status" key will save the setting and move to the next
programming step.
• Pre-Rinse Hours - This setting will only be active if the Pre-Rinse mode is set
to 'Yes' and a flow meter is attached to the control. The display will show
"HOUR" in the left most characters and "XX" in the right most digits where "XX"
represents the hours setting from 01 - 99. The hours setting is adjusted with
the "+" and "-" keys.
Pressing the "Status" key will save the setting and move to the next
programming step.
• Pre-Rinse Time of Day - This setting will only be active if the Pre-Rinse mode is set to 'Yes' and the control is operating
in time clock or Aqua-Sensor
®
mode. The Display will show "TIME" for 2 seconds and then the flashing time display as
in the time of regeneration display. The time can be adjusted in 30 minute increments with the "+" and "-" keys.
Pressing the "Status" key will save the setting and move to the next programming step.
• Efficiency Mode (flow meter only) - Efficiency mode will only be active if the
conditions as explained earlier are met (Not available if DIP switch #6 or DIP
switch #9 are on). The "EFFICIENCY MODE" Icon will be displayed with a
default of "YES". Toggle between "YES" and "NO" with the "+" or "-" key.
Pressing the "Status" key will temporarily store the setting and move to the next
programming step. (This setting will not get saved to EEPROM until the 'status'
key is pressed while at the 'dEFLtS' programming step)
PRE
RI NS E Y
- Culligan Gold Series 1
- Water Softener 1
- i Culligan Gold Series 2
- Introduction 4
- Performance Specifications 5
- Location 7
- Basic Principles 8
- Flow Diagrams 10
- Figure 4 11
- Figure 5 12
- Figure 6 13
- & Refill 14
- Controller Features 15
- Operation 16
- Efficiency Mode 17
- Pre-Rinse Mode 17
- Installation 18
- Mount the Control Valve 20
- Flow Control Eductor Nozzle 21
- Eductor Nozzle Replacement: 21
- Plumbing Connections 21
- Bypass Valve Installation 22
- Drain Line Connection 22
- Connect the Brine Line 24
- Electrical Connection 24
- Figure 21 24
- Figure 20 24
- Programming 25
- 24 Culligan Gold Series 26
- Programming Menus 27
- Display Icons 28
- Custom LCD Display 28
- RI NS E Y 30
- V IEW N 31
- 30 Culligan Gold Series 32
- 32 Culligan Gold Series 34
- Statistics 35
- 34 Culligan Gold Series 36
- Manual Cycling 38
- Backwash 39
- Brine Rinse 39
- Fast Rinse/Refill 39
- Final Start-Up 40
- Recommended Aqua-Sensor 41
- Start-Up Procedure 41
- Use of Bypass Valve 42
- Three-Valve Bypass 42
- Care and Cleaning 42
- Sanitizing Procedure 43
- Analyzing the System 43
- Check the System 43
- Application Problems 44
- Error Codes 45
- Diagnostics 46
- Troubleshooting 48
- 48 Culligan Gold Series 50
- Brine System Analysis 51
- Aqua-Sensor 51
- Circuit Board Test 51
- Optional Service Test 52
- Sensor Probe Resin Test 52
- Preparation 52
- Probe Test 52
- Resin and Regeneration 53
- 52 Culligan Gold Series 54
- Circuit Board Troubleshooting 55
- Circuit Board 56
- Drive Motor Assembly 57
- Seal Pack Assembly 58
- Wiring Schematic 59
- Appendix A 60
- Appendix B 62
- Parts List 64
- 64 Culligan Gold Series 66
- Brine Tank 68
- Brine System - Safety Valve 70
Related products and manuals for Water dispensers Culligan Platinum Series
(2 pages)
(8 pages)© 2020, manymanuals.com. All rights reserved. | 0.837 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals