Culligan ESTATE 2 Specifications

Cat. No. 01-8822-26Rev. B 9/99DCO# 991718ESTATE® 2/2M WATER CONDITIONERInstallation and Operating ManualMODELS FROM 1999©1999 Culligan International

8 / CULLIGAN ESTATE 2/2M WATER CONDITIONERSettingsThe Estate® 2 and 2M Water Conditioners are designed toperform efficiently on a wide range of water

• Loosen the screw and lift the white time-of-day dial androtate it until the desired time of recharge is opposite thepeg (H). Please note that whenev

10 / CULLIGAN ESTATE 2/2M WATER CONDITIONERTABLE 2B — CULLIGAN ESTATE 1.0FT3 WATER CONDITIONER SALT DOSAGE — FREQUENCYTotal Water Hardness in Grains P

REGENERATION FREQUENCYTo set the regeneration frequency, push the number of pins inwhich corresponds to the number located in Table 2 (refer toFig. 9

12 / CULLIGAN ESTATE 2/2M WATER CONDITIONERSALT 0-10 11-20 21-30 31-40 41-50 51-60 61-70 71-80 81-90 91-100DOSAGE (0-170) (171-340) (341-515) (516-685

TABLE 5 — REGENERATION SCHEDULECAPACITY SWITCH POSITION(GALS.) SW2 SW3 SW4 SW5 SW610 OFF OFF OFF OFF OFF100 ON OFF OFF OFF OFF200 OFF ON OFF OFF OFF30

14 / CULLIGAN ESTATE® 2/2M WATER CONDITIONER 160 lb. Brine Tank 250 lb. Brine Tank 375 lb. Brine TankSalt "A" Dime

Start-Up ProcedureWARNING: FOR PROTECTION, A SANITIZINGAGENT HAS BEEN ADDED TO THE SOFTENER TANKAT THE FACTORY. THIS SANITIZING AGENT MUSTBE FLUSHED O

16 / CULLIGAN ESTATE® 2/2M WATER CONDITIONEROperation, Care and MaintenanceUse of Bypass ValveDepending on where the particular installation was made,

• Remove the brine valve chamber by removing the screwson the side of the salt tank.• Remove the salt plate at the bottom of the brine tank.• Lay the

Attention Culligan Customer:The installation, service and maintenance of this equipment shouldbe rendered by a qualified and trained service technicia

18 / CULLIGAN ESTATE® 2/2M WATER CONDITIONERWiring SchematicAutomatic Clock Timer

WIRING SCHEMATIC / 19Wiring SchematicTimer with Soft-Minder® Meter

ESTATE® 2/2M WATER CONDITIONERInstallation and Operating ManualModels from 1999Table of ContentsIntroduction ...

2 / CULLIGAN ESTATE 2/2M WATER CONDITIONERIntroductionPlease read this booklet carefully before beginning theinstallation of the Estate® Water Conditi

SPECIFICATIONS / 3SpecificationsESTATE® 2/2M WATER CONDITIONER0.7 FT3 MODEL 1.0 FT3 MODEL 1.5 FT3 MODELControl Valve Type 5-cycle Reinforced 5-cycle R

4 / CULLIGAN ESTATE® 2/2M WATER CONDITIONERPreparationCOMPONENT DESCRIPTIONThe water conditioner is shipped from the factory in threecartons. Remove a

INSTALLATION / 5InstallationPLACEMENTRefer to Fig. 1.• Set the media tank on a solid, level surface near water,drain and electrical facilities. Place

FIG. 2TEN INCH SOFTENERSAs shipped from the factory, each control is equipped as a 8-inch unit. A 10-inch eductor and flow control is included witheac

CAUTION: When reinstalling back plate tocontrol valve, make sure the u-clip fully engages thetwo bottom holes of the bracket (Fig. 5). Securebracket f